Sensor box SB2G with two NG-Inclinometers and two Amplifiers each with 0.5 to 4.5Volt output signal |
|
Special features SB2G
Description
The SB2G sensor box is a pressure-cast aluminum box ( IP65) with integrated sensor for single axis Inclination or Acceleration measurement.
The SB2G contains two amplifier part each with 0 5VDC output signal possibility, also as a separate part on the board there is a high-stable power supply for supplying the actual sensor ( this can also be taken out as an ref. Voltage ! ). The amplifier for the Signal output, contains also a low-pass filter for upper frequencies limitation. Rise-time constant as a specific value, + an max. current output limitation, can also be a part of the custom built unit. Supply noise suppression filter and diode bridge for guarantee of the Electromagnetic Compatibility are also a standard part in this unit. Sensor and amplifier are galvanic isolated from the housing.
In the SB2G box the NG type sensor are implemented, which means a very high degree of a accuracy on the measuring of inclination and an considerably reduced temperature drift over the whole temperature range, this as the highest degree of accuracy of all SEIKA products.
A strong metal PG cable gland and the solid and compact housing for the whole Sensor box in connection with the high voltage signal output gives al together a high-quality system for use under many types of difficult working conditions.
Applications
The SB2G is used everywhere, where inclination or acceleration measurements are wanted together with a high level DC voltage output. In particular in cars, lorries, radar systems, bridges, ships, in agricultural machinery and in all types of process machinery, just name it !. SB2G can be for very good use nearly everywhere, where very high accuracy are asked for.
Technical Data
Termination | max.: 2 x 1,5 mm2 |
Cable gland | PG7 (Metal with integrated stress relief) |
Measuring ranges | In accordance with NG Sensor |
Protection degree | IP65 |
Mounting | Any direction |
Working planes sensor (NG..Sensor) | parallel and 90° to the base of housing |
Supply voltage to the box | +8 ... +30 Volt |
Operating current | Max. 5mA |
Measuring range of the output signal | +0,5 to +4,5 Volt |
Maximum range of the output signal | +0,05 to +4,95 Volt |
Reference initial voltage | ( 5+/-0,005) Volt ( max.10mA) |
Output impedance | 100W |
Output signal zero | +2,5 Volt |
Adjustable areas via pot.-meters | Signal-zero (2,5V), Span |
Low-pass filter | Active, 3th order, minimal ripple |
Working temperature | -40 ... +85°C |
Options: Special measuring ranges, test report, Silicone filled housing, custom wiring
Dimensions and pin assignments
CAUTION ! Do not short-circuit the operating voltage (8 to 30V) with one of the outputs ! |
Send mail to transducer@ntt.dk with questions or comments about this web site.
Copyright © 2017 Nordisk Transducer Teknik
Last modified: januar 23, 2017